| Download details |
 Turbine kit |
|||||||||||||
| Next.. Insert the bearing hub in the stator plate center hole. You may need to take some sandpaper to clean up the hole to get the hub to slip in. It’s a snug fit. Make sure the bearing hub is flush with the face of the plate before welding. You don’t need to weld all the way around the hub as this is not a structural area, it only holds the stator in place. Four welds equally spaced about ½ to ¾ inch long is more than sufficient. Be careful not to burn through into the bearing surface. The picture below shows how it should look when it’s completed… |
|
||||||||||||
Renewable energy world
Watt is duurzaam
